Get exclusive volume discounts, bulk pricing updates, and new product alerts delivered directly to your inbox.
By subscribing, you agree to our Terms of Service and Privacy Policy.
Direct access to our certified experts
Analyzer
Voltage input
Frequency range: DC - 250 kHz
Input impedance: 1 MΩ / 50 Ω switchable
Connector XLR, unbalanced
Max. input voltage: 100 V continuous (attenuator autoset at overvoltage); 10 V at 50 Ω in -20/0/20/40 dB
Preamplifier: 0/20 dB ADC amplifier
Current input
Frequency range: DC - 250 kHz
Shunts: 10 mΩ / 1 Ω / 100 Ω
Max. input current: 20 A continuous (overload protection)
1 Ω and 100 Ω shunt are protected additionally by an 1.5 A fuse
Connector: 4 mm safety jack (+, -)
Measurement range: 20 A, 10 A, 1 A, 100 mA, 10 mA, 1 mA
AD-converter
Resolution: 16 Bit
Sampling rate: 1.0 MS/s
Generator
Frequency range: DC - 250 kHz
Output impedance: 50 Ω
Connector: BNC, unbalanced
Signal: sine wave / square wave / triangular / DC
Amplitude: 0 – 10V AC, -10V - +10V DC
Resolution: 12 Bit (2.5 mV)
Amplifier
Frequency range: DC – 1 MHz
Connector: 4 mm safety jacks (output) BNC, unbalanced (input)
Current: 16 Arms
Voltage: 50 Vrms / 75 VDC
Distortion (DC – 100 kHz, load ≥ 4 Ohm): < 0.10 %
Voltage amplification: 10 ± 0.1 % (± 0.01 % / °C)
General data
EUT control /Connector: 9-pin Sub-D; RS-232
Connection to computer: USB
Temperature range: 0 to 40 °C
Warm-up time: 15 min
Housing: 19“ subrack or desktop case
Mains voltage: 115 / 230 VAC ± 10%,50-60 Hz
Dimensions(W x H x D): 449 mm x 177 mm x 580 mm
Weight(shipping): approx. 40 kg (net 34 kg)
Option
Loop sensor/radiating loops
Field loops are required to generate magnetic fields. Magnetic fields are measured
with sensor loops. The loops are manufactured according to the definitions in MILSTD 461 and EN 55103.
Helmholtz coil Helmholtz coils are the ideal instruments for generating homogeneous magnetic
fields. The models HCS_50/28 and HCST_50/28 generate field strengths from
1000 A/m to 1 kHz. The MGA 1033 with the optional compensation board is
required for this.
Coupling transformer A coupling transformer is used for testing for conducted immunity on power lines
according to MIL-STD-461, CS 101. Due to the high common-mode voltage on the
mains side, a differential amplifier is built into the coupling transformer, which
enables simple measurement of the coupled differential voltage.
Testing equipement
acc. To EN 55103-2
Annex B of EN 55103-2 describes various test adapters intended for immunity tests
from 50 Hz to 10 kHz.
Datasheet
